unknown routing protocol error setting up bgp on a 3550
Just getting started with BGP. On a catalyst 3550, 12.9 EA1 IOS, OSPF is setup and running fine and I wiih to add BGP for ISP route sharing. When I enter "router bgp 65300" I receive the error "unknown routing protocol". Same error if EGP is attempted. Do I need to redistribute routes first or is there something I am overlooking? I tried removing all routing processes and starting from scratch, enabling BGP without OSPF or any other protocol running...same error.
Re: unknown routing protocol error setting up bgp on a 3550
I believe you have to upgrade to at least 12.1(11)EA1 version. Please take a look at the "Unsupported CLI Commands" for the two versions below (URL). Although BGP is supported in 12.1(11) and above, there are still some BGP commands that it does not support. But it might be better if you can upgrade to the latest version, 12.1(13).
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...