11-25-2003 11:58 AM - edited 03-02-2019 11:58 AM
I have a Catalyst 6509 with Supervisor Engine WS-X6K-SUP1A-2GE with MSFC 1. The memory DRAM is 64Mbps, Flash 16Mbps and NVRAM has 512K.
I want to upgrade from CatOs to IOS.
What IOS version Can I use?
Will It have Problems whit this Job?
Where is the procedure to do it?
thanks.
11-25-2003 12:02 PM
The procedures are at
http://www.cisco.com/warp/public/473/81.html
If 12.1(8b)E15 has all the features you need, it should be a good code. Check the release notes/bug tool kit for known issues before you upgrade
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/12_1e/ol_2310.htm
11-26-2003 09:10 AM
thank for your response;
I forgot that I have two MFSC1 (slot 15 an 16). The procedure indicated before only consider one MFSC1. What Do i do?
11-26-2003 09:17 AM
You will need to do it twice(once for each Sup)
11-26-2003 09:42 AM
I understand. If I have two Supervisors I do it as procedure indicates, twice.
If I have two MFSC1, the same way. I do it twice.
I have a doubt. Where is installed the MFSCs? Each one into SUP?
Thanks
11-26-2003 09:54 AM
The MSFCs are daughtercards on the Supervisor engine. You can use session 15 or session 16 to get to them.
12-22-2003 08:59 AM
thanks friend:
I already have upgradeted my Supervisor 1. It is missing to upgrade the other SP. I have two questions about it:
1.After to upgrade the first SP, the running configuration shows these 3 commans lines:
boot system flash slot0:c6sup11-dsv-mz.121-8b.E15
boot system sup-bootflash:c6sup11-dsv-mz.121-8b.E15
boot bootldr bootflash:c6msfc-boot-mz.121-8b.E15
This is correct? or only must be show some them?
2. When I insert to slot2 the second SP Upgradeted, the syncronizing between SP1 and SP2 is automatcally?
thank you for response.
11-26-2003 02:25 PM
Make sure that only one sup is installed in the chassis while doing the conversion. Otherwise, you may have unexpected results.
11-26-2003 03:06 PM
This should help. Read "Converting from Catalyst Software" from pages 190-192. I had great sucess followed this instruction. Remember one sup at a time. If you have dual sups, pull one from the chasis. Once you converted the first sup, power off and pull it. Reinsert the other sup and follow the same procedure.
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/12_1e/ol_2310.htm
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: