Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Upgrading 6509

Hi,

After I load the new image into Bootflash, do I have to do a full reset or can I just reset module 1.

Thanks,

Steve

1 REPLY
New Member

Re: Upgrading 6509

Hi there,

Check the config if you have the following lines

#set boot command

set boot config-register 0x2

set boot system flash bootflash:cat6000-sup.X-X-X.bin

(X=to the ver number such as, 5-5-5) then you can apply reset. Be sure if you have standby sup it should need to syncronize first. Good luck

88
Views
0
Helpful
1
Replies