Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Upgrading 6513 to 7.6 from 6.3

Hi,

Has anyone come across any issues when upgrading a 6500 series switch with highavailability mode and MSFC2?

I'm planning on upgrading my 6513 this weekend. Cisco publishes the procedure, but Cisco states in this document that the commands must be executeed fromslot 1, the active supervisor.

The problem I see is that slot 2 is my active sup. I'm wondering if I should pull slot 2 to force slot 1 to become the active sup before I begin.

Just looking for some of your experiences. I'm doing this in production so I want to be prepared.

Regards

Jeff

1 REPLY
Cisco Employee

Re: Upgrading 6513 to 7.6 from 6.3

Slot in which you have the active Supervisor should not matter. The following tech tip should help out

http://www.cisco.com/warp/public/473/161.html#maintask3

107
Views
5
Helpful
1
Replies