Upgrading a CAT 5000

[bw3481]

I have a cat 5000 that is running a real old version of software, and I am trying to follow the upgrade process to get it up to a later version. When I issue the download command, the switch will act like it is coping the software for a couple minutes and then the following message appears:

Finished network single module download. (1604139 bytes)

ERROR: module: csum=0x1c2d1916 module.csum=0x5fb9

$$$$synnmp$$$$ module length=0x49c61

Any ideas of what this means, I search around TAC and could not find anything.

Thanks in advance.

[Prashanth Krishnappa]

What kind of Supervisor is it? What software are you upgrading to and from what version? How much DRAM do you have on the switch? If you have a previous output of sh ver, paste it

[bw3481]

Thanks for the reply. It turned out to be a bad image that I downloaded from CCO. I had someone else re-download the image and all is good.

Thanks.