Upgrading flash on a 3845 - which files do I need?
I've run out of room for two IOSes on the puny 64MB CF card that came with our 3845. Couldn't find any info on cisco.com about upgrading flash:/, so I have several larger CF cards lying around and I assume they will work after I put them in the router and reformat them.
Besides the IOS image, which files do I need to save on the new drive? All these tar files are for the HTML interface, I presume, so I don't need them? The config is saved in nvram, which I assume is NOT on the CF card.
Directory of flash:/
1 -rw- 4301 Oct 19 2009 21:03:50 -07:00 flaky-config 2 -rw- 818176 Jan 26 2008 03:39:56 -08:00 common.tar 3 -rw- 741376 Jan 26 2008 03:40:04 -08:00 es.tar 4 -rw- 93095 Jan 26 2008 03:40:08 -08:00 attack-drop.sdf 5 -rw- 1038 Jan 26 2008 03:40:14 -08:00 home.shtml 6 -rw- 1198080 Jan 26 2008 03:40:22 -08:00 ips.tar 7 -rw- 113152 Jan 26 2008 03:40:26 -08:00 home.tar 8 -rw- 3029504 Jan 26 2008 03:40:40 -08:00 sdm.tar 9 -rw- 1651 Jan 26 2008 03:40:46 -08:00 sdmconfig-38xx.cfg 10 -rw- 33676960 Mar 18 2009 10:29:34 -07:00 c3845-ipbasek9-mz.124-22.T.bin 11 -rw- 245911 May 18 2010 23:22:46 -07:00 crashinfo_20100518-062246
A Subquestion: Is it safe to remove the CF card and insert another while the router is running?
I know I could delete the current IOS image on flash:/ and have enough space, but that is living too dangerously.
Re: Upgrading flash on a 3845 - which files do I need?
Thanks to all who replied/ The old "SanDisk Ultra II" card from my old dead digital camera works perfectly.
The CF card was swapped out with the router active, but no one logged in, then reformatted. The manual exhorts one to shut down all "network connections" before swapping out the card, but presumably if no one is logged in the filesystem is not "open" so thee is minimal risk.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...