Upgrading from Hybrid to Native Mode on a Catalyst 6000
I am trying to upgrade from hybrid to native. I have a MSCF2 module, In ROMMON mode i have formatted the bootflash because i had the wrong IOS, I then installed a c6sup bin file. The file uncompressed and when rebooted in hangs at
Start as Primary processor
00:00:03: %SYS-3-LOGGER_FLUSHING: System pausing to ensure console debugging output.
00:00:06: %OIR-6-CONSOLE: Changing console ownership to route processor
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...