Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Upgrading SSL Service Module in Cat6500

Hi,

I'm trying to upgrade a SSL Service Module in one of our 6500.

Following the guide at

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_guide_chapter09186a00805e34ed.html

After booting on the maintenance partition and trying to copy the image I get

(Not enough space on device), looking at the filesystem of pclc# shows a Unix filesystem, I'm not sure what to free up on it.

Any ideas?

Thanks in advance

Mathias Kanstrup

2 REPLIES
New Member

Re: Upgrading SSL Service Module in Cat6500

I'm willing to bet that you are running into a bug here. The bug-Id is: CSCee29521

New Member

Re: Upgrading SSL Service Module in Cat6500

I am seeing the exact same problem. I have a TAC in currently on this issue. The SSL module that we are trying to upgrade is not in production yet. We do have an SSL module which is in production and the partition pclc#x-fs: is 260MB vs. the one that we are trying to upgrade with is only 30MB. Seems to me that the partition was actually incorrectly built, but I am not an expert with the 6509 chassis/Sup Engine. My main responsibility is Content Switching/SSL termination. I will post back if we find solution today.

138
Views
0
Helpful
2
Replies