Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Upgrading Sup2 Module In 6513

I need a document that will explain how to upgrade a 6513 switch with dual supervisor modules. If the primary supervisor is configured do I perform the syn command?

Thanks,

2 REPLIES
Silver

Re: Upgrading Sup2 Module In 6513

Attached is the link for upgrading standard 6500 series switches. Near the bottom is a set of links on how to upgrade when using redundant supervisor blades. You will need to select the link depending on if you are using CatOS or IOS. You will also need to be logged into CCO.

Hope this helps.

Steve

Cisco Employee

Re: Upgrading Sup2 Module In 6513

119
Views
0
Helpful
2
Replies
CreatePlease to create content