05-19-2006 02:09 PM - edited 03-03-2019 03:17 AM
Hi,
I want to identify uplink utilization in the switch.
I am looking for all possible ways.
Regards
skrao
05-19-2006 08:33 PM
Hi SK,
I think the best way will be to check with "sh int" command on uplink ports and see the input rate and output rate and also check broadcast received counters and if any errors.
HTH
Ankur
05-19-2006 10:18 PM
if http server is enabled, you can watch the uplink port utilization through Cisco Network Assistant in GUI
05-20-2006 05:47 AM
On a CatOS use the SHOW TOP command to see the utilization of a port or trunk....
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: