Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

UplinkFast over network with only four 2950

I Have 4 switches 2950 connected each one with the others three and one of them as a root.

1.- Can I activate UplinkFast in order to provide fast convergence in the network access layer after a spanning tree topology change?

2.- Should I activate UplinkFast only on the three wich are not the root?

3.- Can I have problems with this configuration (in terms of uncontrolled loop)

4.- What happen if the root switch is going down? IN that case one of the other three switches with UplinkFast enabled will be the new root.

1 REPLY
New Member

Re: UplinkFast over network with only four 2950

This is not the recommanded us of uplinkfast, but I don't you will have any problems. Use RSTP (802.1w) instead - it supported by the 2950 - then you will get fast convergence.

186
Views
0
Helpful
1
Replies