I would like a suggestion on the best way to do uplink a 4500 with a SUP IV to the core of the network. I have two 6500s in the core, and I am going to uplink the 4500 with a connection to each 4500. I was thinking about using a transport vlan to connect to each 6500. 2 addresses just used between the 4500 and the 6500 and another two for the other uplink. I'm planning on trying to have most devices on the 4500 be on a seperate vlan just for the 4500, but I know that I will have to have devices that are on different vlans defined on the 6500. Should this switch participate in eigrp? What would be the best way to handle this?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...