i have updated the 6509 sup1-2GE from the hybrid IOS TO Native IOS(I RELOADED THE SWITCH MANY TIME).EVERY Thing was fine,today i have restartED the switch it goes to romon"System Bootstrap, Version 5.3(1)
Copyright (c) 1994-1999 by cisco Systems, Inc.
c6k_sup1 processor with 65536 Kbytes of main memory
rommon 1 >
rommon 1 >.
NOW;when i enter the command boot slot:c6sup11-dsv-mz.121-20.E2.the 6509 starting normaly.what is the problem now how can i fix it;i dont need every time to boot manuly.
The register is correct for the RP but my guess is the register on switch processor side is incorrect . At the rommon prompt see if you see what the register is , it is in the switch processor at this point .
To check on the switch procesor side do a "remote login switch" command and this will take you to the switch processor , do a show version at that point . Register should read 0x2102 , if not it needs to be changed.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...