Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

user exec mode AS5300

We have an AS5300 that standard internet users dial into to begin a ppp session. I was wondering if there is a way to stop users from dialing in manually with a terminal and entering commands into the user exec level. I would also like to prevent this when windows brings a terminal up after dial.

Thanks AL

This is a copy of my config.

aaa new-model

aaa group server radius first

server 111.111.111.111 auth-port 1812 acct-port 1813

!

aaa group server radius second

server 111.111.111.111 auth-port 1812 acct-port 1813

server 111.111.111.112 auth-port 1812 acct-port 1813

!

aaa authentication login default group radius local

aaa authentication login consoleport local

aaa authentication login virtualterminal local

aaa authentication login auxiliaryport local

aaa authentication ppp default if-needed group radius

aaa authorization network default group radius

aaa accounting update newinfo

aaa accounting network default wait-start group radius

aaa dnis map enable

aaa dnis map 5555555 authentication ppp group first

aaa dnis map 5555555 authentication login group first

aaa dnis map 5555555 accounting network wait-start group first

aaa dnis map 5555555 authentication ppp group second

aaa dnis map 5555555 authentication login group second

aaa dnis map 5555555 accounting network wait-start group second

interface Group-Async1

ip unnumbered FastEthernet0

encapsulation ppp

ip tcp header-compression passive

no ip mroute-cache

async mode interactive

peer default ip address pool async

no fair-queue

ppp authentication pap chap

ppp multilink

group-range 1 96

line 1 96

modem Dialin

modem autoconfigure type mica2.7.3.0

transport input all

autoselect during-login

autoselect ppp

1 ACCEPTED SOLUTION

Accepted Solutions

Re: user exec mode AS5300

You can do this by configuring "async mode dedicated" on the group-async interface. In this way, PPP is started automatically when the user dials into the access server.

Cheers

2 REPLIES

Re: user exec mode AS5300

You can do this by configuring "async mode dedicated" on the group-async interface. In this way, PPP is started automatically when the user dials into the access server.

Cheers

New Member

Re: user exec mode AS5300

That did the job, thank you very much.

87
Views
0
Helpful
2
Replies
CreatePlease to create content