Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

User Tracking Question/only grabbing a small percentage of addresses

I am trying to grab all of the IP addresses behind a router where my cisco works and core switch are. Where does user tracking get its information. When I say to discover all, it discovers about 30 addresses. There is over 3000 IP addresses (15 subnets) to be discovered in our building. It worked fine on an older version of Ciscoworks. I tried the discover subnets as well and it picked up only a couple more. Where does usertracking go to get info. i thought it was a pinging process. Thanks.

Brian

2 REPLIES
Blue

Re: User Tracking Question/only grabbing a small percentage of a

UT gets its info from Campus Manager. If UT is not discovering the IP address properly, http://www.cisco.com/warp/public/477/Campus/ani.shtml should help in troubleshooting. See the 'Troubleshooting UserTracker' section.

Community Member

Re: User Tracking Question/only grabbing a small percentage of a

The instructions are more Unix based than Windows.. Would not having the default routers private snmp key cause this problem?

89
Views
0
Helpful
2
Replies
CreatePlease to create content