username access-class 10 password xxx ?

[admin_2]

I configured a username Florida access-class 10 password test

then I created the access-list 10 permit 10.1.1.1

Unfortunetly It does NOT restrict access ??

IS there more to this ?

I know I can restrict it by adding access-class 10 in

to the VTY, but I dont want to do that.

any ideas , It seems that this command in the username is useless.

thanks in advance for any help

[rwiesmann]

Hi

If you do the following it should work:

username xxxx access-class 10 password xxxx

!

access-list 10 permit 10.1.1.1

!

line vty 0 4

access-class 10 in

login local

Hope that helps

Roger

[rusdijunaidi]

I have tested this config but the same result that I got, it seems the command username access-class is useless , anyone knows how to use this command ?

-rusdi-

[rwiesmann]

hi

I did test the setup as i posted it above and it

worked. Means if i did not use the right source i was blocked. If i used the right source it asked me for the username/password.

Did you configure the folowing line under the vty?

line vty 0 4

access-class 10 in

Because this one is also needed to work properly.

What is the ios release you are using?

Regards

Roger