Is it possible to use access-lists with priority queuing? I need to prioritize some traffic over others by IP addresses (really, subnets) all of which come into the router via the same Ethernet interface. Nothing fancy... just "if List1 has traffic, it takes priority over List2, which takes priority over List3", etc. PQ's four levels are more than adequate, I just need a way to assign them by IP address rather than by incoming interface.
Would ICMP traffic be considered part of "IP" in access-list 100 as shown above? I want to treat TCP/IP and ICMP separately, relegating ICMP to low priority and TCP/IP to something higher. I know the ACL can separately specify "ip" and "icmp" (and "tcp" for that matter), but how inclusive is that "ip" in the priority-list command?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...