Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

using custom-queueing on GRE Tunnel(?)

i've defined a GRE Tunnel betwenn two routers (one at the customer side and the other in one of my remote data center) can i set a bandwidth and run custom-queueing over it, as i could on serial connections?

1 REPLY
Silver

Re: using custom-queueing on GRE Tunnel(?)

custom queuing is not supported in GRE Tunnel interfaces. You can use a rate-limit command on them which might get you what you need, as far as QOS functions go.

7600(config)#int tun0

7600(config-if)#rate

7600(config-if)#rate-limit ?

input Rate limit on input

output Rate limit on output

7600(config-if)#rate-limit out ?

<8000-2000000000> Bits per second

access-group Match access list

dscp Match dscp value

qos-group Match qos-group ID

Hope this helps you,

Don

101
Views
0
Helpful
1
Replies
CreatePlease login to create content