Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Using netconfig can't push banner configuration

Using netconfig in CiscoWorks I cannot get a sucessful upload of the banner message. It appears that netconfig skips right over this part of the configuration. Has anyone run into this before?

Thanks,

Erik

1 REPLY
Blue

Re: Using netconfig can't push banner configuration

Make sure that you've installed the latest IDU patch for your RME version from CCO. There has been several NetConfig/Banner related issues in older versions.

88
Views
0
Helpful
1
Replies