I need to know how to allow access to a server inside my network from the internet using SDM. I have a 837 router. I need traffic that comes in on port 8001 to go to ip address 192.168.1.1 on port 80. I know I need to use some combination of ACL and NAT to do this, but I don't know what should be in the access-list. How do I set up the NAT, and where do I apply it? I have a DSL connection and there is the ATM0 interface as well as a virtual Dialer1 interface.
I am familiar with PIX firewall. Basically, what I want to do is a static translation (if any ip comes in on port 8001, send it to 192.168.1.1 on port 80) which would be static (in, out) tcp [outstide-ip-address] 8001 192.168.1.1 www netmask 255.255.255.255
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...