Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Using snmpwalk to get the fdb data

I was wondering we have to use private MIB to get the MAC addresses in different VLANs configured on a Catalyst 4006 switch or the MIB-II dot1dTpfdbtable variable is sufficient. I appreciate the response.

2 REPLIES
Blue

Re: Using snmpwalk to get the fdb data

Makre sure that you use Community String Indexing: ftp://ftp.cisco.com/pub/mibs/supportlists/wsc4000/wsc4000-communityIndexing.html

For example, the Catalyst switch includes one instance of the standard BRIDGE-MIB for each Virtual LAN in the switch. If the read-only community string is "public" and the read-write community string is "private", one could use "public@25" to read the BRIDGE-MIB for VLAN 25 and use "private@33" to read and write the BRIDGE-MIB for VLAN 33. If just "public" or "private" is used, the BRIDGE-MIB for VLAN 1 is accessed.

New Member

Re: Using snmpwalk to get the fdb data

I appreciat your help. Thanks.

406
Views
0
Helpful
2
Replies
CreatePlease to create content