It seems to me this would not be an issue, since LAT is layer 2 the switch would just pass the traffic like any other. Set up a VLAN for your LAT nodes and your off. Anyone see any glaring issues I might be missing?
If you have *really* old devices (if your using LAT that's most likely the case), make sure you watch autonegotiation issues. I usually have to fix the ports at speed/duplex to get them to run well. Other thing is using SET PORT HOST command to disable auto-trunking and auto-channeling and enabling portfast on ports with end stations attached. This reduces link-up forwarding delay to under 1 second.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...