Using the <tt>backup interface</tt> Command to Assign a Backup Server
I have a cluster server with one primary server and one secondary server. Both servers are connected to serial ports on a Cisco 1720 router running Cisco IOS<sup></sup> Software Release 12.0. I would like the serial port connected to the secondary server to act as a back up to the primary server (connected to the other serial port). Can I do this by using the backup interface command? Are there other commands I need to use in addition to the backup interface command?
Re: Using the <tt>backup interface</tt> Command to Assign a Back
Yes, you can use the backup interface command to allow the secondary server to act as a backup for the primary server. This means that the primary interface has to go down (for example, if there is keepalive failure, or if the Data Carrier Detect (DCD) signal goes down) in order for the backup interface to come out of STANDBY mode.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...