Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Using wic-1am for Dial-backup

This is probably a newbie question but I haven't been able to find any configuration samples.

I have a small site that is using a partial T1 for internet connection. I need to setup a backup connection for when that goes down. I have an extra wic-1am here and would like to use in this 2600.

I will need the backup to connect to an ISP with one of our accounts (only need the internet connection). Is this something simple to do? The company will not spend the extra for a DSl/ISDN line.

Thanks!

1 REPLY
Cisco Employee

Re: Using wic-1am for Dial-backup

It should be easy to configure dial backup using wic-1am. Here is the link for that

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122limit/122x/122xb/122xb_2/ft12pwic.htm

WIC-1AM is a analog modem so configuration wise its same as other analog modem. So you can visit following url for more specific backup config for serrial line using analog modem

http://www.cisco.com/warp/public/793/access_dial/async_backup_dp.html

155
Views
0
Helpful
1
Replies