Utilization Indicator on Catalyst 4006

[jerry.whitt]

The Utilization Indicator on our 4006 and 4912G never show anything.

Is there something we need to do to enable this indicator.

[Prashanth Krishnappa]

You do not have to enable anything. The LEDs will go up only when the backplane traffic is 20% or higher

[shannong]

The previous post was correct. Additionally, you can use [show system] command to get the current and peak load of the switch.

{sample}

Modem Baud Traffic Peak Peak-Time

------- ----- ------- ---- -------------------------

disable 9600 0% 0% Thu Dec 5 2002, 09:26:45