Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Utilization Indicator on Catalyst 4006

The Utilization Indicator on our 4006 and 4912G never show anything.

Is there something we need to do to enable this indicator.

2 REPLIES
Cisco Employee

Re: Utilization Indicator on Catalyst 4006

You do not have to enable anything. The LEDs will go up only when the backplane traffic is 20% or higher

Silver

Re: Utilization Indicator on Catalyst 4006

The previous post was correct. Additionally, you can use [show system] command to get the current and peak load of the switch.

{sample}

Modem Baud Traffic Peak Peak-Time

------- ----- ------- ---- -------------------------

disable 9600 0% 0% Thu Dec 5 2002, 09:26:45

73
Views
0
Helpful
2
Replies
CreatePlease to create content