v.92 for 3640

[gkaravit]

Hello all

If I am not wrong, the only IP-Plus IOSs that support v.92 on 3640 are 12.2.11-YT2 & 12.2.15T. Both require 96MB RAM and 32MB flash (actually I think 24MB is enough).

Is there any other IP-Plus IOS that requires 64MB RAM that support v.92?

If not is it likely that on a future major release 64MB will be enough?

Rgrds

[makchitale]

v.92 on 3640 is supported on all flavours of IOS (IP, IP Plus etc) on the 12.2(11)YT2 & 12.2(15)T trains...since you are specifically looking for IP Plus, 96/32 megs are the DRAM/Flash requirement....IP requires 32/8 M.

No these is no other IP+ IOS image (that req less than 96 M DRAM) that supports v92 on the 36xx/37xx platform.

http://www.cisco.com/go/fn

Thanks, Mak.

[gkaravit]

Well, the alternative version I found that I could use is the 'Telco feature set' which requires 64MB Ram.

The features we use are:

AAA / Radius Group Server

Virtual Templates / Profiles

l2tp / l2f

EIGRP

PPP / CHAP / PAP

MPPC compression

Multilink / Multichassis Multilink

ACL

SNMP

NTP

which are all supported on the Telco ios. Is there anything I should know about the Telco version, since I've never used it before?