1. The Box runs S/W called IOS which should already be loaded in the flash memory of the box, this IOS is then loaded in DRAM at boot time. So if you boot the router up for the 1st time out the box you should get a question asking to configure the box, if you say NO then you will have a prompt which looks like this "router>"
2. No the console can not be used for ADSL connections, Cisco have a specific module for ADSL
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...