Assuming you already have a serial interface installed in each router and that your LANs are not using the same subnet address, all you need to do is give the interfaces in each router an ip address, in the same subnet and do a no shut on it. This will use the default encapsulation which is HDLC.
Then you will either need to run a routing protocol or just set up static routes on each router pointing to the ethernet subnet of the other router with the serial interface of the other router as the next hop. This is done with the IP ROUTE command.
There is a simple example of ppp configuration at the following URL. Just omit the clockrate command if you are not using a back to back cable connection.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.