Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Very simple router memory question.

Why when I re-boot my router do I have to recofig it everytime. When I do a sh run or a sh start it shows me the correct config.

Thanks, Dan

  • Other Network Infrastructure Subjects
1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Very simple router memory question.

check your config register in sh ver if it is set to 0x2142 it will ignore NVRAM. It should be set to 0x2102

1 REPLY
Silver

Re: Very simple router memory question.

check your config register in sh ver if it is set to 0x2142 it will ignore NVRAM. It should be set to 0x2102

72
Views
0
Helpful
1
Replies