Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

VIC 2BRI-S/T TE or WIC 1B-S/T

Hi,

I have a question that i think i already know but i just wanted to run it by some people.I have a 1760 with a VIC 2BRI-S/T interface installed.When i boot the router it just says "unknown card in slot 2"

From the documentation it seems that these cards only work in the NM-1v and NM-2V modules which a 1760 doesn;t have.This will be used as a dial backup for a WAN link so i assume that i need the WIC-1B-S/T instead.

Before i send it back any help would be gratefully received

Mark

1 REPLY
Bronze

Re: VIC 2BRI-S/T TE or WIC 1B-S/T

The VIC-2BRI-S/T-TE is not supported in the 1700 series. The VIC-2BRI-NT/TE is supported, as is the WIC-1B-S/T. Check this link:

http://www.cisco.com/warp/public/788/products/2isdn_bri_vic.html

253
Views
0
Helpful
1
Replies
CreatePlease to create content