Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VIC-2FXS and IOS image c1700-sv3y-mz.121-5.T10 in 1750

I have IOS image c1700-sv3y-mz.121-5.T10 and two VIC-2FXS in my 1750. If i issued command show voice port summary, i should see status of my voice ports, but it looks like there is no voice ports at all. Upon system boot it finds two VIC-2FXS like it should. Should i initilaize my ports anyway? In IOS 12.2 it works OK.

3 REPLIES
New Member

Re: VIC-2FXS and IOS image c1700-sv3y-mz.121-5.T10 in 1750

Voice ports should be initialized and alos these images will also support the VIC-2FXS

12.0(5)XQ, 12.0(7)T, 12.1(1)T, 12.1(1), 12.2(1), 12.2(2)T, 12.2(2)XH, 12.2(2)XJ, 12.2(8)YJ, 12.2(8)YL, 12.2(8)YM, 12.2(8)YN, 12.3(1)

New Member

Re: VIC-2FXS and IOS image c1700-sv3y-mz.121-5.T10 in 1750

Thank you for answer, but how it should be initialized? Any commands or something?

New Member

Re: VIC-2FXS and IOS image c1700-sv3y-mz.121-5.T10 in 1750

You can do it very easy with Cisco ConfigMaker software. However, you may need a hardware upgrade from 1750 to 1750-4V and software upgrade from IOS IP to IP Plus future set; to install the VIC's.

305
Views
0
Helpful
3
Replies