I have 110 vlanes in a 5500 that it connects for ATM against a lightstream 1010. To this lightstream also it has connected a 7200. We have problems in one of the vlanes of 5500 (vlan 67) since from 7200 doing a show ipx server I do not see the machines of this vlan. The solution has been to connect this vlan in 5500 to 2924 and this equipment for ATM to the lightstream 1010. Someone has spent something similar or has an idea of the possible problem??? Thank you very much..
You are saying about only single VLAN 67. With "sh ipx server" command, we can view only servers like file or print, but not all clients and depends on SAP ACL's in between the server advertisements cann't be forwarded further. So that, it cann't learned by 7200 for VLAN 67 servers. Because of this problem is only for a VLAN, check where the SAP advertisements getting blocked.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...