Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
383
Views
0
Helpful
2
Replies

VLAN change

j-belarj
Level 1
Level 1

‎10-11-2003 03:44 PM - edited ‎03-02-2019 10:56 AM

We have added a new VLAN in our network and changed 3 switchces to the new VLAN (all ports). Now I'm not able to telnet to only those 3 switches. I get the following: "% Authentication failed." I can ping them and all the workstations can communicate with all the servers in other VLANs and get to the internet... I'm using tacacs for authentication. Could that be the pb? any idea? Thanks...

Labels:
0 Helpful
2 Replies 2

mark-obrien
Level 4
Level 4

‎10-12-2003 07:09 AM

Did you change the IP addresses of the switches to addresses in the new VLAN? If so, did you change the entries for these switches in your TACACS server(s) to reflect these new addresses?

HTH

Mark

0 Helpful

Bobby Thekkekandam
Cisco Employee
Cisco Employee

‎10-12-2003 07:19 AM

I would definitely check and make sure the entries in your TACACS server are correct. If you can, it may also be good to try disabling TACACS authentication (get in through the console port) and see if you can telnet then. That should isolate the problem.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents