just brushing up on some basics, like creating vlans/trunks.vtp domains etc. Anyway, I did the below, but, upon re-creating vlan 2 after deleting it, the same status and ports were assigned to it. Should I have reloaded or something, after the delete, before re-creating.? I was of the understanding, that if you delete a vlan, the ports assigned to that vlan become assigned to no vlan.(meaning you gotta reassign them). I was planning to do just that, but, it happened all by itself. Cheers.
I think it has something to with the fact that vlan 2 was not really active , if you look at the first display it shows vlan 2 as act/lshut which means the vlan was shutdown . Probably if you activated the vlan first and then deleted it . Also I don't think it is going to change the "switchport access vlan 2" settings on the switchports unless you manually change them even if you delete the vlan in the vlan database , the database doesn't have anything to do with the switchport settings , those are handled in the running config file.
Most newer Catalyst switches will add a vlan x automatically when you configure "switchport access vlan x" on a switchport interface. However, after that, if the vlan x was deleted, the config on that interface does NOT go away.
vlan information is stored in vlan.dat database and the interface config is stored in NVRAM. They are two separate information base. So what you see is expected on the Catalyst Switches.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...