vlan et 2610

[a.diot]

hi all,

Can i config dot 1Q vlan on a 2610 platform ?

I believe than to perform 802.1Q vlan i need a 10/100

ethernet am i right or wrong

Thanks

[Harold Ritter]

You sure can configure dot1Q with the 2610 FastE. Make sure you have at least IP plus as a feature set.

Hope this helps,

[milan.kulik]

Hi,

generally you need 100 Mbps ethernet to configure 802.1Q on Cisco routers.

But there are some exceptions.

I remember configuring 802.1q on some 3600 10Mbps port in the past.

I don't know if there is any document describing these exceptions.

So just install IP Plus IOS and try if "encapsulation dot1Q" subinterface config command is available.

Regards,

Milan

[Tsasbrink]

Yes, you can for sure, i had a 2611 witch i used to trunk 802.1q with my 3524xl. you do need to have ip plus feature pack, ios 12.2(2) T ,it will not work on a nm-1e but does on the build in ethernet interfaces of the 261x series.

ISL however is not supported.

http://www.cisco.com/en/US/products/hw/routers/ps259/prod_bulletin09186a00800921e4.html