03-08-2004 05:57 AM - edited 03-02-2019 02:06 PM
Hi.
I have a 2950/24 and i need to enable vlans above 1005, I've put the switch in transparent mode but stil I can't enable vlan above 1005. Anybody have any suggestions on this issue? plase help me then!
03-09-2004 01:13 AM
Hi,
do you have an enhanced image enabled on your switch?
Some models (WS-C2950-12 and WS-C2950-24, e.g.) don't support enhanced image (see the Enhance Image note on http://www.cisco.com/cgi-bin/tablebuild.pl/cat2950).
See also http://www.cisco.com/univercd/cc/td/doc/product/lan/cat2950/12119ea1/2950scg/swvlan.htm#1200242
for extended VLAN range details.
Regards,
Milan
03-09-2004 04:32 AM
Hi Milan!
Thx for the quik answer, no I do not have enhanced image on the switch. So that was the answer on my question, thanks again!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide