Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VLAN on catalyst 6513

Can one port be member of two or multiple vlan's. ?? Of course at a time only one VLAN will be active.

3 REPLIES
Cisco Employee

Re: VLAN on catalyst 6513

Normally, a access port on a 6500 can be in only one VLAN only. Few exceptions to this

*A Trunk port(either ISL or dot1q)

*A port configured for aux VLAN to support IP phones

New Member

Re: VLAN on catalyst 6513

The only other instance I can think of is the Private VLANs (PVLANs).

Private VLANs (PVLANs) provide Layer (L2) isolation between ports within the same PVLAN. It's not really two distinct VLANs where the port or device can flip flop between different networks. Rather, it is a configuration where nodes are configured so that while they may be in the same primary VLAN they may be configured to not speak to other nodes unless specifically permitted. A typical implementation would be in a secure DMZ.

Bronze

Re: VLAN on catalyst 6513

Multi-VLAN port is supported only in the Catalyst 2900XL/3500XL switches.

The port can only be connected to a router or server.

It allows users from different VLANs to access a router or a server

without the use of inter-VLAN routing. However, there are some limitations:

- you cannot configure a multi-VLAN port when a trunk is configured on the switch.

- the switch automatically transitions to VTP transparent mode when the multi-VLAN

port feature is enabled.

Just some additional info.

207
Views
0
Helpful
3
Replies
CreatePlease login to create content