Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VLAN question

Hello,

I am the proud owner of a Catalyst 5513.

In this switch there are a few 10/100Base TX Ethernet Cards and a Route Switch present.

On this switch i made some VLAN's and to do some intervlan routing i have some vlan interfaces on the route switch.

My question is: Is it possible to set a default gateway per VLAN? I hope it is a stupid question and everybody but me knows the answer.

Many thanks,

Martijn Koopsen

  • Other Network Infrastructure Subjects
3 REPLIES
New Member

Re: VLAN question

Ofcourse it is, the default gateway of each VLAN will be the IP address of the corresponding VLAN interface configured on the Route Switch Module. Have a look at this for more info:

http://www.cisco.com/warp/customer/473/75.html

Best of luck.

Dazzler.

New Member

Re: VLAN question

Ok,

So far, so good. But i have two gateways to the internet connected to the switch. And depending on the VLAN the user is in the traffic needs to go to one or the other gateway. Is this also possible?

Thanx,

Martijn

Re: VLAN question

You will have to do some policy routing to redirect traffic to respecitve gateways wrt each VLAN.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/qos_c/qcpart1/qcpolicy.htm

Take a look at this.

Policy routing will need to be applied on the incoming vlan interfaces on your RSM. The traffic matching access-list should match the subnet of the desired vlan.

90
Views
0
Helpful
3
Replies