cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
513
Views
0
Helpful
4
Replies

VLAN-support on 1721?

frejac
Level 1
Level 1

According to the feature navigator, my 1721 should support dot1q subinterfaces on my current IOS-build. For now, I'm at 12.3(2)XF advancedsecurity.

However - the command encapsulation dot1q doesnt work.

fw#conf t

Enter configuration commands, one per line. End with CNTL/Z.

fw(config)#int eth0.1

fw(config-subif)#encapsulation dot1q

^

% Invalid input detected at '^' marker.

fw(config-subif)#enca?

encapsulation

fw(config-subif)#encapsulation ?

% Unrecognized command

It recognizes the encapsulation command but nothing after that.

Isnt it supported on 1721, or do I need another feature-set? Or have I missed a command or so? :)

As I said, the feature-navigator told me that it should support this, but perhaps it's incorrect?

Thanks for helping

1 Accepted Solution

Accepted Solutions

mark-obrien
Level 4
Level 4

You probably need a fastethernet interface to run dot1q.

Mark

View solution in original post

4 Replies 4

mark-obrien
Level 4
Level 4

You probably need a fastethernet interface to run dot1q.

Mark

Ahhh, okey. Thanks.

lgijssel
Level 9
Level 9

Hello,

There are two things you need for this:

- You will need IP plus to facilitate VLAN trunking

- VLAN trunking only works on fast ethernet interfaces.

Regards,

Leo

VLAN trunking can also work on ethernet if you have certain IOS version like T train

Thanks,

Siad

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: