Hi friends,
I attached a simple diagram which modelize my question.
As u will see in the sample diagram. I have two networks one has 192.168.1.0/23 as a network address and the other has 10.10.10.0 /24.
I wanna connect these two networks to ASA 5510. But i dont have enough interfaces so i have to use single interface. lets say E1. Also i have an unmanaged switch.
Here is the question: If i configured subinterfaces as E1.100 and E1.200 on ASA. Do i need to set the port on Switch which is connected to ASA as a trunk port? (well.. i couldnt do it... its unmanageable)
Is the following configuration enough to use for my question?
interface ethernet1.100
vlan 100
ip address 192.168.1.1 255.255.254.0
nameif networkA
interface ethernet1.200
vlan 200
ip address 10.10.10.1 255.255.255.0
nameif networkB
or do i need to set any port as trunk?
Thanks alot?
