What I need is 2 Cat 2900 up link to Cat 3550-EMI as below, Need help for configuration for each switch. I would like to know the configuration of them that will help me to understand how to configure the Cat3550 to handle the multi-vlan between the switch. (Cat3550 act as a distribution Layer Switch, Cat2900 act as a Access Layer Switch)
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...