A: The configuration above says that vlan 1 is native vlan, which means the router is expecting a "raw" packet to belong to vlan 1. "raw" packet menas it does not have any vlan id, I do not want to use "tag" coz "tag" might mean something else to Linksys. So, if it's "raw" as in if a PC transmit a packet, it will have no vlan id field.
Problem is all VLAN E ports on switch cannot get past the router.
Some E ports not with VLAN then default to VLAN 1 and they can function past the router.
A: If you mean, they can ping the 22.214.171.124 and beyond 126.96.36.199/24 then that would be expected.
The ports that belongs to other vlans will need a default gateway of their own, they cannot use the vlan 1 gateway because they are in different subnet. from the cofnig above, you only have sub-interface for vlan 1, do you have sub-interface for other vlans? If not, you need it.
The config of the switch was verified with Linksys as being correct which leaves a router config issue
So in short the switch would have 24 VLANs untagged going through trunk which is tagged ending up hitting router and then out WAN ports.
>> This goes back to above, native vlan on cisco router will be the only vlan the router will expect with no vlan id, otherwise, everything the router rx with no vlan id or dot1q encapsulation will be assumed that it belongs to vlan 1. do you have other sub-interfaces on the 2691 for the other 24 vlans?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...