04-15-2003 01:14 AM - edited 03-02-2019 06:40 AM
Help!
I am getting the following error message when attempting to set up a trunk between a 6509 and 2900XL switch:
16:04:05: %SPANTREE-2-RECV_1Q_NON_TRUNK:
Received 802.1Q BPDU on non trunk FastEthernet0/1 on vlan 100.
16:04:05: %SPANTREE-2-BLOCK_PORT_TYPE: Blocking FastEthernet0/1 on vlan 100.
Inconsistent port type
What am I doing wrong!
Many thanks,
JM
04-15-2003 02:43 AM
Hi,
it seems like port configured as 802.1q trunk on 6509 side but as acess port on 2900XL side.
Check if there are
int fa 0/1
switchport trunk encapsulation dot1q
switchport mode trunk
commands in the 2900XL config.
Regards,
Milan
04-15-2003 04:32 AM
Milan,
Thanks for your prompt response, I have now got the trunk to work by ensuring that the interfaces on both switches are on the same native VLAN. However, I am now unable to PING the default router even though I have created a VLAN interface with an IP address and default gateway of the MFSC switch.
Any ideas?
Man thanks,
JM
04-16-2003 11:58 PM
Hi,
you need
interface VLANx
ip address ........
no shutdown
!
ip default-gateway ..........
in your switch config.
The default gateway address must be the IP address of your default router which has to be in VLANx.
Regards,
Milan
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide