Does anyone know if you can create two distinct vlans on the same layer 3 switch using different private ip addressing schemes? I currently have several vlans under 172.16.x.x. I have just run into a situation where I must configure an end node with a 192.168.x.x IP address. Does anyone have any suggestions?
d- absolutely. If I understand your question correctly. Locally, the layer-3 switches you use don't discern between private and public IPs, it treats them all the same. It is only when you try to push these addresses out to the internet that they are dropped. So, creat a vlan on your L-3 switch and apply your 192.168 address just as you would anywhere else. Let me know if you have any further questions.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.