07-31-2006 10:45 PM - edited 03-03-2019 04:18 AM
hi i am new to Vlans.....i have 2550 switch and a router (2620)...so i want to configure some vlans and also config my router to do intervlan routing........so plz some one can post me conf.....for botyh router and switch.....cheers and thanks in advance
07-31-2006 11:04 PM
Hi,
For configuring VLANs on your switch 2550, you just need to enter the following commands:
-enable
- configure terminal
- interface vlan 'no'
Then you need to make various physical interfaces, a member of the VLAN you desire. For that enter the following commands:
-enable
-configure terminal
- interface fa'no'
-switchport access vlan 'no'
Refer the following link for details:
As for how to configure InterVLAN routing on your router, refer the following links:
http://www.cisco.com/en/US/tech/tk389/tk390/technologies_tech_note09186a00800949fc.shtml
Hope this helps.
Regards,
AbhisheK
Please rate all posts!!!
08-02-2006 06:43 AM
hello
check the following link, I think its easier:
http://www.cisco.com/en/US/tech/tk389/tk390/technologies_configuration_example09186a00800949fd.shtml
Vlad
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: