Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VLANs and traffic shapping

Hi, I have:

Cisco 2800 with HWIC 4ESW module (4 port FE switch), IOS 13.3(8)T8, Feature Set IP. 10 VLANs are defined, 2 assigned directly to 2 4ESW ports, 2 port are trunk.

How to configure traffic shapping on VLANs? I need shape 10Mbits from one Giga port to 10x 1Mbits for every VLAN.

When I use this configuration, Giga interface is shapping, but VLAN running without shape.

It is possible?

Thank you.

Libor

access-list 111 permit ip any any

!

class-map match-all class11

match access-group 111

!

policy-map policy11

class class11

shape average 1000000

!

interface GigabitEthernet0/0

ip address 192.168.0.222 255.255.255.0

ip nbar protocol-discovery

service-policy output policy11

duplex auto

speed auto

!

interface FastEthernet0/0/0

switchport access vlan 11

no ip address

!

interface Vlan11

ip address 10.11.12.1 255.255.255.248

ip nbar protocol-discovery

service-policy output policy11

1 REPLY
New Member

Re: VLANs and traffic shapping

Hi, put the service-policy command under the FE0/0/0 directly. Since there is only 1 VLAN defined there, you should otain the expected result.

HTH

288
Views
0
Helpful
1
Replies