I have Cisco 877 series Router. I was about to create VLAN 2 and VLAN 3 for Servers and Wireless. But it says, it cannot create more than 1 VLAN.
So, does this router don't support more than 1 Vlan. Can any one tell me, from which serious we can assign more than one vlan.
Aslo, can any one suggest me is there is any other way to create more than 1 valn in 877 series itself by upgrading the IOS or by any other means.
Solved! Go to Solution.
Just did a check on Feature Navigator for this and it seems that you need one of the following feature sets for this:
ADV. IP SERVICES
ADV. ENTERPRISE SERVICES
It is supported on the following versions:
12.4(4)T1 ADV. IP SERVICES c870-advipservicesk9-mz.12.4-4.T1
12.4(4)T1 ADVANCED SECURITY c870-advsecurityk9-mz.12.4-4.T1
12.4(4)T ADV. IP SERVICES c870-advipservicesk9-mz.12.4-4.T
12.4(2)XA1 ADV. IP SERVICES c870-advipservicesk9-mz.12.4-2.XA1
12.4(2)XA ADV. IP SERVICES c870-advipservicesk9-mz.12.4-2.XA
12.4(2)T2 ADV. IP SERVICES c870-advipservicesk9-mz.12.4-2.T2
12.4(2)T1 ADV. IP SERVICES c870-advipservicesk9-mz.12.4-2.T1
12.4(2)T ADV. IP SERVICES c870-advipservicesk9-mz.12.4-2.T
12.3(14)YT1 ADV. IP SERVICES c870-advipservicesk9-mz.12.3-14.YT1
12.3(14)YT ADV. IP SERVICES c870-advipservicesk9-mz.12.3-14.YT
12.3(8)YI3 ADV. ENTERPRISE SERVICES c870-adventerprisek9-mz.12.3-8.YI3
12.3(8)YI3 ADV. IP SERVICES c870-advipservicesk9-mz.12.3-8.YI3
12.3(8)YI2 ADV. ENTERPRISE SERVICES c870-adventerprisek9-mz.12.3-8.YI2
12.3(8)YI2 ADV. IP SERVICES c870-advipservicesk9-mz.12.3-8.YI2
12.3(8)YI1 ADV. IP SERVICES c870-advipservicesk9-mz.12.3-8.YI1
Hope that helps.. pls rate the post if it does.
I dont think you will be able to configure VLAN's on a router. VLAN's can only be created on a switch. Please tell me what you need to achieve using VLAN's. If its inter VLAN routing, you need not create VLAN's in the router.
No, this router acts like a switch for VLAN creation.
From priv. mode eg
and create vlans by typing eg:-
vlan 2 name voice
then they should show up in "sh vlan"
If you want the router to have an IP address on each vlan , do this from global config mode
ip address xxx.xxx.xxx.xxx mask
interface VLAN 2
ip addres xxx.xxx.xxx.xxx mask
(pretty unusual eh?)
As already mentioned by paresh u need to have minimum ADVANCED IP SERVICES FEATURE SET in ur IOS code which can support max 4 802.1Q Vlans in 870 Series routers..
do check out this data sheet for the same..