Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Vlans comunication

IO use a catalyst 3550 12T, i have made 3 Vlans and i want that the Vlan1 and the Vlan2 cane communicate

Thanks

3 REPLIES

Re: Vlans comunication

Suppose you have an L3 image & correctly setup vlans.

conf t

int vlan1

ip adress x.x.x.x 255.255.255.0

int vlan2

ip adress x.y.y.x 255.255.255.0

end

The configured IPs are the gateway adresses. Thats all!

New Member

Re: Vlans comunication

Ok the ip are the gateway adresses but i need that the Vlan 1 can communicate whith 2 Vlan how does i do

thanks

Re: Vlans comunication

With the given config in place, you can route between the two vlans.

On layer2 (bridging) there is no connectivity between vlans.

When you want layer2 connectivity, you need to have ports within the same vlan.

87
Views
1
Helpful
3
Replies