Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VLANs with an older Catalyst 2924XL

I have an older Catalyst 2924XL with 11.2 (8) SA6 IOS (the latest I could find for the older 4mb/1mb switches) and I want to integrate it into my network. The problem is I have 5 VLANs running and I can't get it to trunk anything (ie. It doesn't have any of the normal trunking commands, like switchport mode trunk). So I thought, well at the very least I should be able to set it up off of another switch with that port in one VLAN and then all the ports on the 2924 will be in that one VLAN right? Well I can't get it to work.....does anyone have any ideas? Thanks in advance guys!

1 ACCEPTED SOLUTION

Accepted Solutions
Purple

Re: VLANs with an older Catalyst 2924XL

You should be able to run it as a regular switch as long as all the ports are in the same vlan , by default with these switches every port is in vlan 1 unless otherwise changed , we have hundreds of these in our network . You can still define separate vlans for the switch you just can't trunk them to another device . This is just off the top of my head so someone can correct me if I am wrong . If you want to get them back to factory defaults , at the command line issue the "write erase" command and then reload without doing a write mem and this will load factory defaults with nothing configured .

4 REPLIES
Purple

Re: VLANs with an older Catalyst 2924XL

I'm not sure the older 2924's were able to handle trunking at least non enterprise edition 4 meg boxes .

New Member

Re: VLANs with an older Catalyst 2924XL

Really? I guess I was confused becuase, with this version of IOS there is a vlan database and vtp commands. But there is no switchport mode trunk command, only switchport mode multi and switchport mode access. It's a bummer cause I can't upgrade the memory and I can't seem to even get it to act like a dumb switch (ie. Have all the ports in the same VLAN). I would be perfectly happy if I could get it to act as a dumb switch.

Purple

Re: VLANs with an older Catalyst 2924XL

You should be able to run it as a regular switch as long as all the ports are in the same vlan , by default with these switches every port is in vlan 1 unless otherwise changed , we have hundreds of these in our network . You can still define separate vlans for the switch you just can't trunk them to another device . This is just off the top of my head so someone can correct me if I am wrong . If you want to get them back to factory defaults , at the command line issue the "write erase" command and then reload without doing a write mem and this will load factory defaults with nothing configured .

New Member

Re: VLANs with an older Catalyst 2924XL

I should have posted that I figured out my problem! Thanks for the feedback it is most appreciated. You are exactly correct in what my problem was. I was putting all of the ports in a certain VLAN instead of leaving it in the admin vlan 1. Then I just put the "mother switch" (-technical term, hehe) port in the VLAN that I wanted and it worked perfectly! I was just thinking to hard about this problem and I should've just done a quick 'write erase' and started from scratch. Thanks again for all the posts they were very helpful!

124
Views
0
Helpful
4
Replies